Use & care guide

ManualsBrandsMonogram ManualsKitchen AppliancesZISB36D

ZKHSS1 for 1/4" Panels

Tubular Stainless Steel [-[nz_ctles

This kit provides for the installation of Stainless Steel custom

handles on 1/4"thick decorator door panels. The door extru-

sions allow these custom handles to be secured to the door

structure, rather than to the custom panels, This kit contains

all the necessary parts for dispenser and non-dispenser

models.

Toolsand materials required:

•#2 Phillips screwdriver

• Drill and 1/8",9/32"bits

• Custom door panels

• Safety glasses

• Center punch

• Masking tape

• Hammer

• Pencil

• 1/2"thick 12"x 12"min, piece of plywood

to protect floor when drilling

• For stainless steel panels wear gloves to

protect against sharp edges.

PartsList:

A. Fresh food door extrusion

B. Freezer door extrusion

C.2 Stainless tubular handles

D. 10Spacer rings (for Stainless panels ONLY)

(8required, 2 extra)

E.8 Handle standoffs

F.10Screws for mounting handle standoffs

(8 required, 2 extra)

G. 10Set screws (8 required, 2 extra)

H,3/32"Allen wrench for set screws

Note: It is best that 2 people install this kit.

Giiiii

Step 1:

Remove

Handles

• Open doors to 90 °. Remove the screws from the full-

length handles of both doors.

• Retain screws, discard handles.

• Locate the 2"x 2" adhesive foam pads packed with

the refrigerator. Apply pads to the doors as shown.

Corner pads should be as close to inside corners as

possible.

[]

Note: If a custom collar is to be used,order ZWCD1Trim Kit

for 36"and 421'wide models, Order ZWCD2for 481'wide

models,