Use & care guide

Option I Installation
ZKHT1 Trim Kit (For 3/4" Panels)
Support for Custom Hi, holies
OPTION 2
For dispenser
model using
full-width
trim
Before
you
begin
Note: Optimal final 1 13/16" _1-1 :}/16"
appearancedependson careful Back Side y_,_1/4" Max. _ _ %ok Side
routing depth. Do not exceed _ .................................................................................J
1/4" routingdepth. Handle Side Handle Side
All 3 custom door panels must be routed to accommo-
date the door extrusions. Route the panels as
illustrated, max. 1/4" deep, 1-13/16" wide, top to bottom
on the handle side.
FreezerPanel FreshFoodPanel
Refer to installation instructions for ZKT36 trim kit,
Option 2.
• Follow Step No. 1 to remove standard aluminum trim.
• Follow Step No. 2 and 3 to attach new 3/4" trim pieces
and install panel support brackets.
Step 1
Locate position
of handle
Note: Tilecustom handlemust
be installed against tile handle
bracket.Tile customhandle
cannotexceed11o3/4"length.
Temporarily Temporarily
Secure Secure
Handle Dispenser
Bracket Trim
With With
Screws Screws
• Position the handle bracket onto the steel door by
matching existing screw holes on the door and
bracket.
• Re-install dispenser trim, temporarily.
• Determine the desired location of the custom handle
and carefully mark centerlines of the screw holes.
• Drill 1/16" pilot hole through the trim until it starts
into the handle bracket. This marks the same location
onto the bracket.
• Remove dispenser trim and bracket.
36