Use & care guide

ZKHT1 Trim Kit (For 3/4" Panels)

Support for Custom H;_nctles

Step 1

Temporarily

mount

door panels

• Place the prepared 3/4"custom door panels on the

bottom trim with support bracket tabs inserted into

slots.

• Push the panel back against the steel door, making

sure panel is flush with hinge side trim.

• Secure the panel to the trim temporarily by driving

2 screws through the back side of the trim at the top.

• Slide door extrusion in between panel and steel door.

Temporarily secure with 2 screws.

Step 2

Locate

position

of handles

• Determine the desired location of the custom handles

and carefully mark centerlines of the screw holes.

The handles must be located 3/4" to 1-1/2" from the

end of the extrusion.

• Again, with both doors closed, check centerlines of

the screw holes to be sure they are parallel to the

edge of the door, and level with opposite door.

• Drill 1/16" pilot hole through the panel until it starts

into the aluminum extrusion. This will mark the

matching location for drilling a clearance hole when

assembling the extrusion, panel and handle.