Use & care guide

ZG2 Trim Kit

GHlle Panel Frame Ac[j't/stment

FOR83",83-1/2"

AND 84-1/2"

INSTALLATION

HEIGHTS

• This kit provides optional side trim pieces for the

original grille frame to fit 83", 83-1/2" or 84-1/2"

installation heights.

To change grille panel size:

• Determine the installation height by measuring the

enclosure from the floor to the underside of soffit.

When there is no soffit, measure to the top of

adjacent cabinets.

• Adjust refrigerator case trim to desired height. See

Production Installation.

• Select the side trim pieces for your installation height.

Installation Panel Side Trim Panel

Height Width Lengths Height

83" 35" 8-1/4" 8"

83-1/2" 35" 8-3/4" 8-1/2"

84-1/2" 35" 9-3/4" 9-1/2"

E. Mount the assembled panel by dropping into slots

on the case trim.

A. Locate original grille panel frame supplied with the

refrigerator.

• Remove 8 screws (two on each corner) as

illustrated. Discard original side trim pieces.

B. Select correct size of side trim pieces (3 sets

provided).

• Secure new side trim pieces to original bottom trim.

Important: Maintain 1-1/2"min.gap betweentop of doorsand

bottomof grille panel,

C. Remove barrel nuts from original side trim pieces (2

each side).

• Re-install the barrel nuts on the new side trim pieces

you have selected.

D. Slide custom panel into front slots.

• Secure the top trim piece to the frame with "L"

brackets and screws.