Use & care guide

Option I Installation

ZKH1 Trim Kit (For 1/4" Panels)

Support for Custom H;_nctles

Step 2

Locate position

of handles

_.../Door Extrusion

Note: Handlemustbe located

3/4" to 1ol/2" from edgeof

extrusion.

Min.

lq/2" Max

• Slide custom panels into fresh food and freezer door

frames.

• Temporarily secure the new door extrusions to the

doors. Use at least 2 screws on each door.

• The handles must be located :3/4"to 1-1/2" from the edge

of the extrusion.

• Determine the desired location of the custom handles

and carefully mark centerlines of the screw holes.

• Again, with both doors closed, check the location of

the centerlines to be sure they are parallel to the edge

of the door, and level with opposite door.

• Drill 1/16" pilot hole through the panel until it starts into

the aluminum extrusion. This will mark the matching

location for drilling the clearance hole when assem-

bling the handle, panel and extrusion.