Owner's Manual

Design Guide - Stainless Steel Installation
42
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted to
90° or 130° if clearance to adjacent cabinets or walls
is restricted. Order WX14X99 door stop for precise
settings between 90° and 130°.
When Installed into a corner:
Allow 25” (63.5 cm) for a full 130° door swing. Allow
15” (38.0 cm) for pan removal. Allow 4” (10.16 cm) min.
clearance when door swing is adjusted to a 90° opening
for pan access, but pan removal is restricted.
25"
Min. to
Wall
130°
130° Door
Swing
CLEARANCES
ZUG2, ZUGSS2 Unified Grille Panel Kit
• If you are installing two units, side by side, the
installation space must be 71-1/2” (181.61 cm) wide.
NOTE: Additional cutout width may be required when
side panels are used. Add side panel thickness to the
finished cutout to calculate rough-in width.
• The water and electrical locations for each product
must be located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply
is recommended for each product.
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door
swing product, a 1” (2.54 cm) clearance between the
units is required. Order ZUGSS2 Stainless Steel Unified
Grille Panel Kit or ZUG2 Custom Panel Unified Grille
Panel Kit for one continuous grille panel.
Clearances for two products installed side-by-side
with the same (left or right) door swing
Allow 2” (5.04 cm) minimum clearance between the
products to prevent door swing interference. Order the
WX14X99 adjustable door stop to reduce the factory set
115° door swing. Allow 15” (38.0 cm) minimum to a wall
to achieve full drawer extension and pan removal.
NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT fit
this installation.
2"
15"
Clearances for two products installed side-by-side
with right and left side hinges together
Allow 5” (12.7 cm) minimum between the two products
to prevent one door from striking the other. Use the
WX14X99 adjustable door stop to reduce the factory set
115° door swing and to allow pan removal.
NOTE: ZUG2 and ZUGSS2 Grille Panel Kit will NOT fit
this installation.
5"
INSTALLATION