Installation Instructions

7
Design Guide - Standard Installation
36" Frame to
Frame Width
*84" From
Floor to
Top Frame
35"
Case Width
*83 1/2"
at
Rear
25-3/8"
Case Depth
Depth Including
3/4” Panel - Handles: 25-15/16"
THE INSTALLATION SPACE
Water And Electrical Locations
Electrical and water supply must be located as shown.
The cutout depth must be 24” (60.96 cm)
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Allow minimum 1/8” (0.32 cm) air gap between case
back & wall.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot
exceed the 24” (60.96 cm) installation depth shown.
The top case trim overlaps the bottom of the soffit.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• Water line can enter the opening through the floor
or back wall. Route SmartConnect
™
kit or 1/4” O.D.
copper tubing between the cold water line and the
water connection location. The tubing should be
long enough to extend to the front of the refrigerator.
Installation of an easily accessible shut-off valve in
the water line is required.
DIMENSIONS AND CLEARANCES
* Shipping height. The
refrigerator can be
adjusted to fit into a
cutout that is 83-1/2
”
(212 cm) min. to 84-1/2
”
(214.63 cm) max.
height. Note that the top
case trim at the front is
1/2
” (1.27 cm) higher
and will overlap upper
cabinetry or soffit. Use
leveling legs and wheels
for a maximum 1
” (2.54
cm) height adjustment.
Product Clearances
These refrigerators are equipped with a 3-position
door stop. The factory set 115° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
23-5/8"
Behind
Frame
90°90°
18-1/2”
4 9/16” Min.
Distance to Adjacent
Wall from Cutout
6"
Wall View
Electrical
Area
84-1/2" max
Finished
Opening
75" From
Floor to
Bottom
of Electrical Area
10"
24" Cutout Depth
35-1/2"
Finished Width
2-5/16"
5"
10"
10"
3-1/2" 3-1/2"
5"
3-1/2"
Water Supply
12-5/16"
Min. to
Wall
12-5/16"
Min. to
Wall
130°
130°
The finished
cutout width
must be
35-1/2”.
Allow 12-5/16” (31.27 cm) minimum clearance for a
full 130° door swing.
For a 90° door swing, allow 4 9/16” (11.59 cm) min.
clearance to adjacent wall from cutout. If the 90°
door stop position is used, pan access is maintained,
but pan removal is restricted.
See illustrations pages 11 and 12 to determine
door swing interaction with adjacent cabinets or
countertops.
9 1/4"
Min. to
Wall
9 1/4"
Min. to
Wall
115°
115°
31-1000451 Rev. 0