Installation Instructions

28
31-1000169 Rev. 4
STEP 11 SLIDE UNITS INTO
ENCLOSURES
ŶRoll the units into the enclosure, being careful not to
pinch the water lines or power cords.
Ŷ5HPRYHDOOWDSHRQWKHIURQWRIHDFKXQLW
Ŷ$ORQJIODWEDURU\DUGVWLFNPD\EHQHHGHGWRJXLGH
the front edge of the anti-tip bracket over the unit.
ŶIf space allows, you may also bend the front edge of
the bracket upward slightly, allowing it to clear the
back of the unit.
ŶRemove top-center trim cover from units.
ŶSecure the unit to the Anti-tip bracket using both
machine screws & washers to engage the threaded
inserts in the anti-tip bracket.
ŶHand start the screws until unit is in desired location
within the install space.
ŶFinalize unit install by tightening the screws fully.
ŶReinstall trim covers.
Installation Instructions
INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
STEP 12 INSTALL HINGE GUARD
ŶLocate panel attachment set in the bottom drawer.
Ŷ8VLQJVFUHZVSURYLGHGDWWDFKKLQJHJXDUGVWRWKH
upper and lower hinge side of the door.
Hinge Guard
STEP 13 CONNECT HEATER
Ŷ&XWWKHUHPDLQLQJEDQGVDQGUHPRYHWKH(36EORFNV
from the bottom of the units.
Ŷ5HPRYHWRHNLFNVDQGYHQWVIURPWKHERWWRPVRIWKH
units.
Ŷ/RFDWHDQGSOXJKHDWHUVLQWRHOHFWULFDOKDUQHVVHV
using jumper included with Heater Unification Kit.
Heater
Vent
Screw
Toekick
Vent
Screws
(behind
toekick)
Screw