Installation Instructions

3
31-1000169 Rev. 5
Safety Information
Contents
WARNING
EXPLOSION HAZARD Flammable Refrigerant
This appliance contains isobutane refrigerant,
R600a, a natural gas with high environmental
compatibility. However, it is also combustible.
Adhere to the warnings below to reduce the risk of
injury or property damage.
1) When handling, installing and operating the appliance,
care should be taken to avoid damage to the
refrigerant tubing.
2) Service shall only be performed by authorized service
personnel. Use only manufacturer-authorized service
SDUWVƎ
3) Dispose of unit in accordance with Federal and Local
Regulations. Flammable refrigerant and insulation
material used require special disposal procedures.
Contact your local authorities for the environmentally
safe disposal of your unit.
4) Keep ventilation openings in the appliance enclosures
or in the built-in structure clear of obstruction.
5) Do not use mechanical devices or other means to
accelerate the defrosting process.
6) Do not damage refrigerant circuit.
7) Do not use electrical appliances inside the food
storage compartment of the appliance.
Design Guide
Cabinet Enclosure Dimensions for
Fully Integrated Instructions 4
Unit Dimensions with 3/4” Panels 5
Cabinet Enclosure Dimensions for
Single or Multiple Units 6
The Installation Space (per unit) 7
Grounding the Unit 7
115° Door Swing 8
90° Door Swing 9
Panel Accessories & Dimensions 10
ƎFP&XVWRP3DQHO'LPHQVLRQV 
Installation Instructions for Single Unit
Tools, Hardware, Materials 12
Step 1. Remove Packaging 13
Step 2. Install Anti-tip Bracket 14
Step 3. Connect Water Line 14
Step 4. Connect Power 14
Step 5. Slide Unit into Enclosure 15
Step 6. Remove Toekick and Vent 15
Step 7. Level Unit 15
Step 8. Install Toekick and Vent 16
Step 9. Reverse Door Swing 16
Step 10. Adjust Door Swing 17
Step 11. Install Door Bracket Covers 17
Step 12. Install Door and Drawer Panels 18
Step 13. Start Icemaker 19
Installation Instructions for Multiple Units
Tools, Hardware, Materials 20
Step 1. Remove Packaging 21
Step 2. Install Heater Unification Kit(S) to Unit 2 22
Step 3. Reverse Door Swing (Unit 1) 24
Step 4. Adjust Door Swing (Unit 1) 26
Step 5. Install Door Bracket Covers (Unit 1) 26
Step 6. Installing Other Units 26
Step 7. Join Units 26
Step 8. Install Anti-Tip Brackets 27
Step 9. Connect Water Line 27
Step 10. Connect Power 27
Step 11. Slide Units into Enclosures 28
Step 12. Install Hinge Guard 28
Step 13. Connect Heater 28
Step 14. Level Units 29
Step 15. Install Toekick And Vent 30
Step 16. Install Front Trim 30
Step 17. Install Door and Drawer Panels 31
Step 18. Start Icemaker 32