Installation Instructions

31-1000169 Rev. 5

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)

STEP 2 INSTALL HEATER

UNIFICATION KIT(S) TO UNIT 2

(cont.)

Ŷ Move the two (or more) units together and align the

front.

Ŷ Attach units 1 and 2 at the back using screws and

nuts from the =8*+HDWHU8QL¿FDWLRQNLW-RLQDQ\

remaining units in the same way.

Joining

Bracket

Spacer Clip

Top of Unit Top of Unit

Joining

Bracket

STEP 3 REVERSE DOOR SWING

(UNIT 1)

Ŷ Remove the top and bottom trim covers from unit 1.

WARNING

Follow all steps when reversing

the door swing. Failure to follow these instructions,

leaving off parts, or overtightening screws, can

lead to the door falling off and result in injury and

property damage.

1. Pull the front tape down far enough to open the

refrigerator door.

WARNING

Door Hinge Pinch

Point Hazard

This next step is important for safe handling of an

unloaded hinge. Do not skip step 2.

2. Release the hinge springs by using a Torx T-20

wrench to loosen the Torx screw from | to 0 on both

hinges. Close the door.

Top Trim Cover

Bottom Trim

Cover