INSTALLATION INSTRUCTIONS with Design Guide Fresh-Food Refrigerator Bar Refrigerator with Icemaker Monogram.
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector’s use. Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Consumer. • Note to Consumer – Keep these instructions with your Owner’s Manual for future reference. If you received a damaged refrigerator, you should immediately contact your dealer or builder.
Consignes de Sécurité AVERTISSEMENT Risque d’explosion. Conservez les matériaux et vapeurs inflammables tels que l’essence à l’écart de votre réfrigérateur. Le non-respect de cette instruction peut entraîner un risque d’incendie, d’explosion ou de décès. AVERTISSEMENT Pour réduire le risque d’étouffement pendant l’installation de ce produit, ne pas laisser les petites pièces à la portée des enfants âgés de moins de 3 ans. BRANCHEMENTS ÉLECTRIQUES AVERTISSEMENT Risque d’électrocution.
Installation Instructions CONTENTS Important Information .................................................2 Parts Required ..............................................................4 Caring for Your Stainless Steel .....................................4 Tools, Hardware ...........................................................4 Staining Wood Drawer Fronts ......................................4 Install Water Line .........................................................
Installation Instructions INSTALL WATER LINE (ZIBI240 AND ZIBS240 MODELS ONLY) WARNING Connect to potable water supply only. AVERTISSEMENT Raccordez l’appareil à une alimentation d’eau potable seulement. • A cold water supply is required for automatic icemaker operation. The water pressure must be between 20 and 120 p.s.i. (137-827 kPa). • The water line can enter the opening through the floor or back wall. Route 1/4” O.D.
Design Guide For models ZIFS240 and ZIBS240 with Stainless Steel Doors and Handles THE INSTALLATION SPACE Flush Installation NOTE: Water line location for ZIBS240 model only 1/4” Filler panel or cleat to be set back even with front of case. CABINET Front edge of product case Front face NOTE: Handle and handle standoff depth is 2-1/4”. *For a standard installation: The product must be installed so that the stainless steel front will project 1-5/8” forward of adjacent cabinets.
Design Guide For models ZIFS240 and ZIBS240 with Stainless Steel Doors and Handles SIDE-BY-SIDE INSTALLATIONS PRODUCT CLEARANCES For a complete refreshment center, install a FreshFood Refrigerator beside a Double-Drawer Refrigerator, Beverage Center or Wine Chiller/Wine Reserve. Or, install a Refrigerator with Icemaker beside a Wine Chiller/Wine Reserve.
Design Guide For models ZIFI240 and ZIBI240 with Custom Door Panels and Handles SIDE-BY-SIDE INSTALLATIONS THE INSTALLATION SPACE NOTE: Water line location for ZIBI240 model only NOTE: If installing between frameless cabinets, a 1/2” wide filler strip or side panel may be needed on the hinge side. The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with the cabinet door swing. The width of the opening must include the filler panels.
Installation Instructions STEP 1 REMOVE PACKAGING AND INSTALLATION PARTS • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. • Remove the toekick attached to the back of the unit. • Remove the custom panel attached to the front of the unit. WARNING Small objects are a choke hazard for children. Remove and discard any parts not used. AVERTISSEMENT Les petits objets peuvent étrangler les enfants.
Installation Instructions STEP 2 REVERSING THE DOOR (Cont.) (ZIFI240 model only) • Install the new left bottom hinge pin and new door stop that are enclosed in the hardware bag. STEP 2 REVERSING THE DOOR (Cont.) (ZIFS240 model only) WARNING Follow all steps when reversing the door swing. Failure to follow these instructions, leaving off parts, or overtightening screws, can lead to the door falling off and result in injury and property damage.
Installation Instructions STEP 2 REVERSING THE DOOR (Cont.) (ZIFS240 model only) STEP 2 REVERSING THE DOOR (Cont.) (ZIFS240 model only) • Move the plug on the toekick from the left to the right and reattach toekick to the unit. • Insert the new top plug/bushing in the new top of the door. • Rotate the door 180°. • Re-insert the black screw post in the new bottom of the door. • Remove top plug/bushing from the door using a flat head screwdriver. Discard the bushing. • Rotate the door 180°.
Installation Instructions STEP 3 INSTALL CUSTOM 3/4” DOOR PANEL AND HANDLE (ZIFI240 and ZIBI240 STEP 3 INSTALL CUSTOM 3/4” DOOR PANEL AND HANDLE (ZIFI240 and ZIBI240 models only) 3/4” Overlay Panel Dimensions Model ZIFI240 and ZIBI240 require a field-installed overlay door panel. Overlay Panel • The overlay panel must be Door secured to a 1/4” thick backer panel that slides into the trim. A .10” thick spacer panel must be placed between the overlay and 1/4" backer panel. .
Installation Instructions STEP 3 INSTALL CUSTOM 3/4” DOOR PANEL AND HANDLE (ZIFI240 and ZIBI240 models only) • Slide overlay panel into the door trim. • Reinstall the side trim using the trim screws removed earlier. STEP 4 LEVEL • Use an adjustable wrench to turn the leveling legs and raise or lower the product. For built-in installation, adjust the leveling legs slightly below the bottom of the countertop.
Installation Instructions STEP 6 CONNECT POWER • Connect power cord plug to a properly grounded receptacle. • Check to make sure power is on by opening the door to see if interior light turns on. • Bar Refrigerator with Icemaker – The interior fan runs all the time except during defrost cycle when the door is open. • Fresh-Food Refrigerator – The interior fan runs all the time except when the door is open. See the Owner’s Manual for further explanation of the fan.
Notes 31-51544-10 15
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. NOTE: Product improvement is a continuing endeavor at Monogram. Therefore, materials, appearance and specifications are subject to change without notice. 31-51544-10 02-19 GEA Monogram.
