Owner's Manual

Installation Instructions - Flush Installation

STEP 8 INSTALL GRILLE PANEL

• Raise the grille panel to stop position.

• Loose screws on side trim behind frame. Remove

bottom trim.

• Slide panel over the metal backer panel and into

the trim.

• If necessary, tap with a wood block until panel slips

under the top trim piece.

• Reassemble bottom trim. Tighten screws.

STEP 9 INSTALL DOOR PANELS

AND CUSTOM HANDLES

• Open door to 90°. Remove the 4 Phillips head screws

from the door handle.

• Remove the handle. Retain all screws.

• Remove the 4 screws holding the trim, then lift off the

trim. Retain the screws.

• Custom handles must be used for flush installation.

The handle must be properly secured to the overlay

panel before sliding the panel into the trim.

• The cabinet manufacturer will supply the custom

handle and hardware.

• Discard the supplied handle.

• Slide the overlay panel into the door trim.

• reinstall trim by securing with all 8 screws retained in

previous steps.

• Follow the same procedures to install the drawer

panel.

Adjust nut below spring to

accommodate panel weight

Loosen

side

trim

screw

Loosen

side

trim

screw

Raise

grille

panel

31-49142 Rev. 2