Owner's Manual

Optional Accessory Kits
• ZKHCSS2: Monogram Tubular Stainless Steel handles
designed to fit 3/4” (1.9 cm) overlay panels. This kit also
includes a handle side trim for custom handles.
• ZKHPSS1: Professional Tubular Stainless Steel Handle
designed to fit 3/4” (1.9 cm) overlay panels. Kit includes
one handle. Order 2 kits for bottom-freezer refrigerators
from your Monogram supplier.
• ZUG2: For side-by-side installation of two trimmed
bottom-freezer refrigerators. This kit provides for the
installation of a unified custom grille panel to span the
width of two units using a framed or overlay panel.
• ZKHCT: Handle side trim for left-hand and right-hand
doors. For use on custom panels when using a custom
handle.
28
Design Guide - Flush Installation
3/4” (1.9 cm) RAISED GRILLE PANEL ROUTING
For 3/4” (1.9 cm) raised grille panel, routing is required. The router depth is 1/4” (0.63 cm) all the way around the
panel back. Additional panel width reductions are required per the diagrams below. This will create a “picture frame”
routing that will slide onto the attached grille trim.
3/4” PANEL SIDE VIEW
(AFTER ROUTING)
3/4” PANEL BOTTOM VIEW
(AFTER ROUTING)
Front
TOP
DETAIL TOP
CORNER VIEW SHOWING
“PICTURE FRAME” ROUTING
DETAIL BOTTOM
BOTTOM
LEFT
SIDE
RIGH
T
SIDE
DETAIL
LEFT SIDE
DETAIL RIGHT
SIDE
Back
Front
Back
Front
Back
NOTE: Routed areas should be
finished as they may be visible
when assembled.
2-1/16” 2-1/16”
ROUTER DEPTH 1/4” ROUTER DEPTH 1/4”
3/16”
1-11/16”
ROUTER DEPTH 1/4”
NOTE: For panels constructed with rails and stiles (5-panel), the minimum width is 3” (7.62 cm) for rails and 4” (10.16 cm)for stiles.
31-49142 Rev. 2