Quick Specs

ZIC360NHRHMONOGRAM 36" BUILT-IN BOTTOM-FREEZER REFRIGERATOR
Product Specification Revised 1/18
NOTES
Trimmed refrigerators are designed
to be customized with decorative
panels. Field-installed 1/2" or 3/4"
custom door, drawer and grille
panels are required. For 3/4" raised
panels, routing is required. The router
depth is 1/4" all the way around
the panel’s backs. Additional panel
width reductions are required per
the diagrams shown. This will create
“picture frame’ routing allowing the
panels to slide into the attached door,
drawer and grille trims.
Maximum total panel weight:
• Fresh food door panels – 58 lbs.
• Freezer drawer panel – 28 lbs.
• Grille panel – 11 lbs
Note: For panels constructed with
rails and stiles (5-panel), the rails
must be a minimum of 3" wide and
stiles must be a minimum of 4" wide.
Door Handles
Door handles not included.Custom
handles supplied by your cabinet
maker may be used.
ZKHPSS1: Professional tubular
stainless steel handle designed to
fit custom panels. Kit includes one
handle – 30-1/2" long. Order
2 kits from your Monogram supplier.
ZKHCSS2: Custom European tubular
handle designed to fit custom panels.
Kit includes 2 handles. Door handle is
44-3/16" and drawer handle is
33-3/16".
Order ZUG2: Unified grille kit for
dual installation. Maximum total panel
weight - 25 lbs.
ZKHCT: Handle side trim for left-hand
and right-hand door. For use on a
custom panel when using a custom
handle.
Grille Panel
Fresh
Food
Panel
Freezer Drawer Panel
A
B
C
D
A B C D
38" 10 11/16" 46 9/16" 22 7/16"
PANEL DIMENSIONS
FLUSH INSET 3/4" PANEL DIMENSIONS SINGLE INSTALLATION
3/4" RAISED DOOR PANEL ROUTING
3/4"
11/32"
1/4"
1/4"
1/4"
7/16"
DETAIL TOP
DETAIL BOTTOM
DETAIL
LEFT SIDE
DETAIL RIGHT
SIDE
2-1/16"
2-1/16"
ROUTER DEPTH 1/4" ROUTER DEPTH 1/4"
1/4"
3/32"
TOP
FrontBack
BOTTOM
3/4" PANEL SIDE VIEW
(AFTER ROUTING)
3/4" PANEL BOTTOM VIEW
(AFTER ROUTING)
LEFT
SIDE
RIGHT
SIDE
Front
Back
Front
NOTE: Routed areas should be
finished as they may be visible
when assembled.
CORNER VIEW SHOWING
“PICTURE FRAME” ROUTING
Back
FLUSH INSET
INSTALLATION