Installation Instructions

Installation Instructions - Flush Installation

STEP 9 INSTALL DOOR PANELS

Install door panel:

• Open door to 90°. Remove the 4 Phillips head screws

from the door handle.

• Remove the handle. Retain all screws.

• Remove the 4 screws holding the trim, then lift off the

trim. Retain the screws.

Custom Handles

• Custom handles must be used for flush installation. The

handle must be properly secured to the overlay panel

before sliding the panel into the trim.

• The cabinet manufacturer will supply the custom handle

and hardware.

• Discard the supplied handle.

• Slide the overlay panel into the door trim.

• reinstall trim by securing with all 8 screws retained in

previous steps.

• Follow the same procedures to install the drawer panel.

31-49142-1