Installation Instructions

34
Installation Instructions - Flush Installation
STEP 7 ADJUST DOOR SWING
NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a
90° opening. Skip this step if door opening is
satisfactory for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
• Reinstall the wire cover trim.
WARNING
d
Door Trim Pinch Point Hazard
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
AVERTISSEMENT
d
Risque de pincement
de doigts
Une installation incorrecte peut poser un risque de
coincement de doigts entre la garniture de porte latérale
et les armoires en actionnant la porte, en particulier
pour les enfants. Pour réduire ce risque, vous devez
suivre les instructions d’installation relatives aux
dimensions d’armoire, au montage des garnitures et à
l’angle de l’arrêt de porte.
Pin Location
for 90°
Door Swing
Pin Location as
Shipped for 115°
Door Swing
STEP 8 INSTALL GRILLE PANEL
• Raise the grille panel to stop position.
• Loose screws on side trim behind frame. Remove
bottom trim.
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
Remove grille screws
Adjust nut below spring to
accommodate panel weight
Loosen
side
trim
screw
Loosen
side
trim
screw
Raise
grille
panel
31-49142-1