Installation Instructions

STEP 6 ALTERNATE ANTI-TIP PROCEDURE
The refrigerator must be secured to prevent tipping.
If the anti-tip bracket cannot be used, this alternate
method can be used to prevent the unit from tipping.
• Raise the grille panel to access case trim.
• Use a 3/16” (0.47 cm) bit to drill four evenly spaced
clearance holes through the metal top case trim.
• Use a 1/16” bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4” min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2” (3.81 cm) drywall screws into the
pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.
33
Installation Instructions - Flush Installation
STEP 5 INSTALL ANTI-TIP BRACKET (cont.)
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
from the grill on the left.
• Pull the bottom of each grille forward, down and out to
remove.
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille on the right and 3
from the grill on the left.
• Pull the bottom of each grille forward, down and out to
remove.
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the
back of the unit.
• The unit has “L” bolts in the upper left and right corners
inside of the access compartment. These bolts will
interlock with the wall bracket and secure the unit
using the washers and hair pin cotters in the hardware
kit once the unit has been leveled and is in the final
position.
Top Case Trim
Install four 1-1/2” drywall screws through
trim and into soffit or 3/4” min. wood brace
3/4” Min.
Side View Top
Case Trim
Raise grille panel to
stop position
Drive screws through case
trim into adjacent cabinets
Remove grille screws
Remove grille screws
31-49142-1