Installation Instructions

STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4” (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
STEP 2A WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM
Skip this step when not using an RO System
If the water supply to the refrigerator is from a Reverse
Osmosis Water System, use the refrigerator’s filter
bypass plug. Using the refrigerator’s water filtration
cartridge with the RO filter can result in hollow ice
cubes.
31
Installation Instructions - Flush Installation
STEP 4 INSTALL CASE TRIM
The unit arrives with case trim for standard installation
attached. Flush installation case trim is provided.
Remove the factory installed case trim. Install new
case trim using supplied right hand and left hand case
trim pieces and case trim screws. Attach case trim to
each side of case as shown in illustration using case
trim screws in holes provided down each side of the
case.
STEP 5 ANIT-TIP PROCEDURE
WARNING
Tip Over Hazard.
These refrigerators are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the refrigerator with the anti-tip system.
AVERTISSEMENT
Risque de
basculement
Ces réfrigérateurs présentent une partie supérieure
lourde, en particulier avec une porte ouverte; ils
doivent donc être fixés pour prévenir le basculement
vers l’avant et le risque concomitant de blessure
grave ou fatale. Lisez et suivez les instructions
d’installation complètes pour l’installation du système
anti-basculement.
• Cut a 1” (2.54 cm) x 4” (10.16 cm)
block, 35” (88.9 cm) long.
• Measure and mark under the soffit,
5-1/4” (13.33 cm) from the front edge
of the cabinet.
• Secure the wood block to under the
soffit. From the bottom of the block
to the finished floor should measure
84” (213.36 cm). See the illustration.
• The kit supplied with the unit contains 2 lag bolts and
4 toggles with bolts. The wall bracket will be attached
to the wall in 4 places.
• Measure
the opening
where the
unit is to be
installed.
Mark the
center with a
vertical line.
• Measure up
82” (208.28
cm) from the
floor. Mark
this point on
the wall.
• Using a
level, draw a
horizontal line
on the wall at
this height.
82”
To Floor
Filter Bypass Plug
31-49142-1