Installation Instructions

STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4” (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
STEP 2A WATER LINE
INSTALLATION WITH
A REVERSE OSMOSIS
SYSTEM
Skip this step when not using an RO System
If the water supply to the refrigerator is from a Reverse
Osmosis Water System, use the refrigerator’s filter
bypass plug. Using the refrigerator’s water filtration
cartridge with the RO filter can result in hollow ice
cubes.
13
Filter Bypass Plug
Installation Instructions - Standard Installation
STEP 4 ANIT-TIP PROCEDURE
WARNING
Tip Over Hazard.
These refrigerators are top heavy, especially
with any doors open, and must be secured to
prevent tipping forward which could result in
death or serious injury. Read and follow the
entire installation instructions for securing the
refrigerator with the anti-tip system.
AVERTISSEMENT
Risque de
basculement
Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une
porte ouverte; ils doivent donc être fixés pour
prévenirle basculement vers l’avant et le risque
concomitant de blessure grave ou fatale.
Lisez et suivez les instructions d’installation
complètes pour l’installation du système anti-
basculement.
• The kit supplied with the unit contains 2 lag bolts and
4 toggles with bolts. The wall bracket will be attached
to the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2” (207.01 cm)from the floor. Mark
this point on the wall.
• Using a level, draw a horizontal line on the wall at this
height.
31-49142-1