Installation Instructions
10 49-60615-4
Tempered glass shelves in the fresh food 
section enable you to make efficient shelf 
arrangements to fit your family’s food storage 
needs.
To adjust shelves: Tilt the shelf up at the front 
and slide it up or down along the back wall to 
the placement you want.
Handle glass shelves carefully. Rough 
handling of tempered glass can cause it to 
shatter.
To remove shelves: 
NOTE: To remove a shelf, all shelves under it 
must first be removed.
1. Remove any food from the shelf.
2. Remove covers at the bottom of each track.
3. Tilt the first shelf up at the front.
4. Slide the shelf down along the back wall 
until you reach the bottom where the notch 
is located. Slide the shelf through the notch. 
5. Repeat for removing the other shelves.
To replace shelves: 
Replace shelves by perform steps 1 through 4 
in reverse.
Adjustable 
shelves
Vegetable Pan/Shelves
30” Bottom-Freezer
Vegetable 
pan
The Vegetable Pan in the fresh-food section 
of the refrigerator has LED strip lighting above 
the drawer. 
There are adjustable dividers with several 
different position options. The divider is held in 
place by a tab located under the handle, a slot 
located on the back wall and a stabilizing rib on 
the bottom of the drawer for each position.
To change the divider position:
1. Pull up on the back of the divider to release 
it from the slot in the back and off of the tab 
in the front. 
2. Slide the divider into a new location, making 
sure it seats into the rib on the bottom of the 
drawer. 
3. Pull up on the back of the divider to locate 
the front under the tab at the new location.
4. Push down on the back of the divider to seat  
it into the slot at the new location.
Lighted 
vegetable 
drawer shelf
The lighted vegetable drawer shelf provides 
lighting for the lower compartments. The lights 
are recessed into the shelf to illuminate the 
drawers below.
To remove the shelf:
1. Lift the shelf and carefully pull forward to 
expose the wires.
2. Unplug the shelf and carefully remove it 
from the refrigerator.
To replace the shelf:
1. Carefully set the shelf onto the side rails, 
leaving the plug exposed.
2. Plug the shelf into the refrigerator.
3. Carefully slide the shelf into place.
Cover
LED lights are located 
under the shelf at the front
Lighted 
Vegetable 
Drawer Shelf
Lift shelf and 
pull forward
Ribs
Tab
Slot
Front
Back










