Installation Instructions

31-1000169 Rev. 4

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)

STEP 2 INSTALL HEATER UNIFICATION KIT(S) TO UNIT 2 (cont.)

Ŷ Place the heater harness into the hole using the strain

relief from the kit and push wiring connector towards

the front of the unit.

Ŷ Reattach back cover.

Ŷ Attach joining bracket to unit 2 using screws from

the kit.

Ŷ Remove tape and band from unit 1.

Ŷ Attach joining bracket to unit 1 using screws from

Heater Unification Kit.

Ŷ Attach trim cover holder clips to the left side of unit 1,

4mm from the front edge. Clip 1 should line up with

the hole at the upper left corner. Clip 4 should line

up just below the top door. Clips 2 and 3 should be

evenly spaced between the 2. Notice these clips are

GLႇHUHQWIURPWKHRWKHUV&OLSDWWDFKHVRQWKHERWWRP

front corner, 4mm from the front edge. Clip 5 should

be spaced evenly between clips 4 and 6. Clip 7 should

be attached to the upper right corner, 4mm from the

back edge. Clip 8 should be attached to the back edge

of the refrigerator lined up with the hole in the joining

bracket.

Spacer Clips Spacer Clips

1,4-8 2, 3

Joining

Bracket

Back Cover

Strain

Relief