Installation Guide

31-51544-11 7
PRODUCT CLEARANCES
The Fresh-Food Refrigerator or Bar Refrigerator with
Icemaker is factory set for a 110° door swing.
When installed in a corner:
• Allow 14” minimum clearance on the hinge side for a
full 110° door swing.
• Allow 4” min. clearance on the hinge side for the 90°
door swing and to allow racks to slide out.
NOTE: Clearances are based on the recommended
2-1/4” handle standoff depth.
NOTE: Right-hand models illustrated. Allow the same
clearances on the opposite side for left-hand fresh food
models ZIFI240 and ZIFS240 only. Models ZIBI240 and
ZIBS240 are not available with left-hand door swing.
• Test the door swing. Carefully open and close the
door. The door should not rub or catch on adjacent
cabinetry.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for air
circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 100°F (37°C).
• These products are not designed to be stacked one
over the other.
7
14" Minimum to Wall
110
110 Door
Swing
21-5/8"
23-5/8"
4" Minimum to Wall
90
90 Door
Swing
For models ZIFS240 and ZIBS240 with Stainless Steel Doors and Handles
Design Guide
SIDE-BY-SIDE INSTALLATIONS
For a complete refreshment center, install a Fresh-
Food Refrigerator beside a Double-Drawer Refrigerator,
Beverage Center or Wine Chiller/Wine Reserve.
Or, install a Refrigerator with Icemaker beside a
Wine Chiller/Wine Reserve.
• A side-by-side installation requires at least a 47-1/2”-
wide minimum opening for standard installation and
48”-wide minimum opening for flush installation. No
trim kits required.
• Products must operate from separate, properly
grounded receptacles.