Installation Guide

14 31-51544-11
Installation Instructions
STEP 6 CONNECT POWER
• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
• Bar Refrigerator with Icemaker – The interior fan runs
all the time except during defrost cycle when the door
is open.
• Fresh-Food Refrigerator – The interior fan runs all the
time except when the door is open.
See the Owner’s Manual for further explanation of the fan.
STEP 8 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner’s Manual for more information. Allow 12–24
hours for the temperature to stabilize.
NOTE: The Fresh-Food Refrigerator or Bar Refrigerator
with Icemaker operate very quietly. You may not notice
the unit running, and when first installed, the fans and
motor may not come on immediately – this is normal.
If the display is lit and the light is working, the unit is
operating.
STEP 7 SLIDE PRODUCT INTO
THE CUTOUT
NOTICE: Do not push against the door panel with your
knees. Do not push or lift the unit by the door handle.
Damage may occur.
• Open the door and gently push the unit back into the
opening with your hands against the sides. Be careful
not to entangle power cord.
• In a standard 24” opening, the front face of the
stainless steel door will be flush with adjacent
cabinetry. A custom panel door may protrude 1-3/4”
beyond the surrounding cabinets.
• Check again to be sure the unit is level.
• If the unit is installed under a countertop, adjust the
leveling legs until the unit is resting firmly against the
underside of the countertop.
• If alignment with adjacent cabinetry is an issue, use
a shim to secure the unit against the underside of the
countertop.