Installation Instructions

31-1000642 9
For Models ZIFI240 and ZIBI240 with Custom Door Panels and Handles
for Standard Installation only
Design Guide
PRODUCT CLEARANCES
The Fresh-Food Refrigerator or Bar Refrigerator with
Icemaker is factory set for a 110° door swing.
When installed in a corner:
• Allow 16” minimum clearance on the hinge side for a
full 110° door swing.
• Allow 4-1/2” min. clearance on the hinge side for the
90° door swing and to allow racks to slide out.
NOTE: Custom handle clearances may vary.
NOTE: Right hand models illustrated. Allow the same
clearances on the opposite side for left hand fresh food
model ZIFI240 only. Model ZIBI240 is not available with
left hand door swing.
• Test the door swing. Carefully open and close the
door. The door should not rub or catch on adjacent
cabinetry.
NOTE: When installing custom panel and handle,
use above clearances as a general guide but adjust
according to the installation.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for air
circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 100°F (37°C).
• These products are not designed to be stacked one
over the other.
THE INSTALLATION SPACE
Flush Installation not allowed with custom Door
Panels and Handles
Standard installation
The product must be installed so that the product front
will project forward of the adjacent cabinets by the
dimensions T or U according to the model in the chart.
This position will allow a full door swing and prevent
interference with adjacent cabinetry. The opening
between cabinets must be a minimum of dimension K.
16" Minimum to Wall
110
110 Door
Swing
4" Minimum to Wall
90
90 Door
Swing
R
F
B
Standard
Installation
Front edge of
product case
Front face
CABINET
CABINET
110°
120°
T,U
In a standard installation, the product
will project forward of adjacent
cabinets. See
T,U.
Product Extended Dimension
T ZIFI240 2-3/4”
U ZIBI240 2-5/8”