Installation Instructions

14 31-1000642
STEP 3 INSTALL CUSTOM 3/4”
DOOR PANEL AND
HANDLE
(ZIFI240 and ZIBI240
models only)
• Slide overlay panel into the door trim.
• Reinstall the side trim using the trim screws removed
earlier.
• Place the brushed decorative cover over the side trim
to hide the screw heads. Ensure side trim is aligned top
to bottom and front to back. Snap into place.
STEP 4 LEVEL
• Use an adjustable wrench to
turn the leveling legs and raise
or lower the product. For built-in
installation, adjust the leveling
legs slightly below the bottom
of the countertop.
INSTALLATION TIP:
Measure floor to underside of
countertop inside the opening.
If the room floor is higher
than the opening floor, adjust the rear leveling legs
approximately 1/8” less than the opening height. Screw
front legs all the way in to shorten the height at the
front. This will allow you to slightly tip the unit into the
opening. Once in the correct position, the front legs can
be adjusted to level the product.
STEP 5 CONNECT WATER SUPPLY
(ZIBI240 and ZIBS240 models only)
WARNING
Connect to potable water supply
only.
AVERTISSEMENT
Raccordez l’appareil à une
alimentation d’eau potable seulement.
• Locate and bring the water line tubing to the rear of
the cabinet.
• Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4” nut and ferrule over both ends of the
copper tubing. Insert the tube into the refrigerator
connection on the unit and tighten the nut.
• Turn on the water to check for leaks.
GE SmartConnect™ Tubing: Follow the instructions
provided with the tubing. Over tightening may cause
leaks. Turn on the water to check for leaks.
NOTE: Coil excess tubing behind the unit.
Installation Instructions
Turn Right to Lower
Turn Left to Raise
NOTE:
For shipping
purposes, the
brushed decorative
cover will be
secured to
the front of
the unit.
Water line
WARNING
Electrical Shock Hazard
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
AVERTISSEMENT
RISQUE DE DÉCHARGE
ÉLECTRIQUE Fixez le collier de serrage dans le
trou présent seulement. NE PERCEZ PAS dans le
réfrigérateur.