Specification Sheet
Product Specication Revised 10/19PAGE 3 OF 4
For questions about your
appliance, please call 1-800-626-2000.
INSTALLATION
Door
1/4" Backer Panel
.10" Spacer Panel
Trim
3/4" Overlay Panel
34 1/2"
(87.6) min
underside of
counter to floor
35" (88.9) max
24" (61.0)
min cutout depth
CUTOUT INSTALLATION
SIDE VIEW
INSTALLATION CUTOUT
FRONT VIEW
ELECTRIC/
WATER
A" (aa)
B"
(bb)
23 3/4" (60.3)
min standard
24 3/4" (62.9)
min flush inset
10 1/2" (26.7)
1 1/2" (3.8)
9"
(22.9) max
ZIBI240PII
• Installation Space: is module
can be installed beneath a countertop
or can be used free-standing.
• For a standard installation of
stainless steel unit: e product
must be installed so that the front
face will project 1-5/8" forward of
adjacent cabinets.
• For a flush installation of stainless
steel unit: Install a 1" wide filler
strip on the hinge side. e width
of the opening must be 24-3/4" min.
wide. See installation instructions
for details.
• Location Requirements: All
Monogram Refrigeration Modules
may be closed in on the top and sides
as long as the front is unobstructed
for air circulation and door swing.
Do not install these products where
the temperatures will go below 55° F
(13 C) or above 90° F (32 C).
Products must operate from separate
properly grounded receptacles.
ese products are not designed to
be stacked one over the other.
See installation instructions for
side-by-side information.
NOTES
PRODUCT DIM. A
ZDWI240, ZDB1240 1"
ZDWR240, ZDBR240 1"
ZIB1240, ZIF1240 1"
ZIFS240, ZIBS240 1/4"
ZDOD240 1-1/4"
PRODUCT DIM. A
ZDWI240, ZDB1240 2"
ZDWR240, ZDBR240 1-3/4"
ZIFS240, ZIF1240 1-5/8"
ZDOD240 1-7/8"
ZIB1240, ZIBS240 2-5/8"
CABINET CABINET
Dim. A
Front Edge of
Product Case
Front Face
Standard
Installation
110º
120º
In a standard installation, the
product will project forward of
adjacent cabinets. See Dim. A.
23 3/4" min.
CABINET CABINET
These products will fit flush to adjacent
cabinets when installed with a Dim. A - width
filler panel or cleat. The filler panel should be
recessed or set back behind the door and
even with the front edge of the product case.
110º
120º
Flush
Installation
Filler panel or cleat to be set
back even with front of case.
Front Edge of
Product Case
Dim. A
Front Face
24 3/4" min. width
stainless steel models
REFRIGERATION MODULES, TOP VIEW
INSTALLATION CUTOUT
SIDE VIEW
INSTALLATION CUTOUT
FRONT VIEW