ZHU30RSPSS, ZHU36RSPSS, ZHU30RDPBB, ZHU36RDPBB
12 49-2000868 Rev. 1
BLUETOOTH
®
PAIRING
Pairing a Bluetooth
®
Device
Refer to the literature for the supported device to make sure
it is ready to be paired. NOTE: The Hestan Cue® Quick
Guide can be found in the literature packet.
Hold the Precision Cooking pad for 3 seconds until display
reads “Add”. Tap to initiate pairing mode on the unit and
will blink, then activate your device to initiate the device’s
pairing mode. Refer to the table below for device specific
instructions.
When stops blinking, device
has been added. Repeat this
step for each additional device.
Up to 5 devices will be stored in
memory. To exit Pairing, touch
Precision Cooking pad one time,
or menu will automatically exit
after 60 seconds of no user
input.
PRECISION COOKING
The Precision Cooking feature allows precise temperature control of certain cooking devices for improved results.
Initiating a Precision Cooking Mode
1. Touch the Precision Cooking pad.
2. Any burner available for Precision Cooking will flash.
This excludes any burner on in standard mode. If no
Precision Cooking devices are paired, no burners will
flash as available. NOTE: Only one burner may run a
Precision Cooking mode at a time. If another precision
mode is attempted, the burner in use for Precision
Cooking will flash.
3. The display will read “SEL”, instructing you to select a
burner to use.
4. Touch the On/Off pad for the desired burner, or press
Sync Burners to use Precision Cooking across the two
left burners.
Removing Bluetooth® Devices
Hold the Precision Cooking pad for 3 seconds until display
reads “Add”. Tap so that display shows “dEL”, then
tap to delete all paired devices. The icon will turn off
when complete. NOTE: Your unit cannot delete a single,
or specific device. All of your paired device will be deleted
simultaneously. After all devices are cleared, devices you
wish to use must be paired again.
USING YOUR COOKTOP
Supported Devices How to Initiate Pairing
Hestan Cue
®
Cookware Tap pan handle twice
Precision Probe Press side button once