Installation manual

Installation Preparation
P1"ofessiollal Gas Cooktops
Installation
Options
These cooktops can be installed in standard
24" or deeper 25" cabinets.
• In 24" deep cabinets, the fi'ont of the
cooktop will project approximately 1-7/8"
beyond the fi'ont of the countertop.
• In 25" deep cabinets, the cooktop will be
flush with the fi'ont of tile countertop.
26-5/8"
21q/4"
High __
Back /
/
Low Back
Countertop _ 12"
8-7J16,,Z lj2,,5
' 1
3" to CenterLine_II ,_
ii
of GasInlet /_,,_22-3/4"
1/2" _ 23-1/4"
2-1/2'_I
CabinetFace-ProjectingControlPanel_
CabinetFace- FlushControlPanel_
• The stainless surface of tile cooktop will be
1/2" higher than adjacent countertop.
• Cooktop fits flush to rear of cutout, no
additional suf)port is required.
0
Oooktop
1/2"AboveA@acent
Counte)tops.
FrontProjectsOutwardasShown
FromStandardDepthCabinets.
O
Cooktop 1/2" AboveAdjacent
Countertops,
FrontFlushWith Cabinets-a Minimum
of 25-3/4" CabinetDepthRequired
Advance
Planning
Refer to "Dimensions and Clearances" for
appropriate placement and necessary clear-
ances when planning the installation.
• Cabinetry can not be installed directly above
the cooktop.
• We recommend the installation of a vent
hood above the cooktop surface.
The vent hood should be at least 24" deep.
The vent hood should be the same width as
the cooktop.
-For 48" models, we recommend the vent
hood blower be 1200 CFM.
For 36" models, we recommend the vent
hood blower be 600 CFM.
• Refer to hood installation instructions for
height dimensions.
• Working areas adjacent to the cooktop
should have 18" minimum clearance
between countertop and cabinet bottom.
• Clearance between cooktop and side wall or
combustible material must be at least 12" on
each side.
• These cooktops require 8" free space below
the countertop.
• If the cooktop is installed in an island:
-Allow 12" rain. clearance at the back to
combustible materials.
Allow 36" rain. above the cooking surface to
combustible materials.
• Installation must conform with local codes.
In the absence of local codes, the gas
cooktop must comply with the National Fuel
Gas Code, ANSI Z223.1-1990.
A.G.A. approved.