Installation Instructions
49-85246-1 39
Before you 
call for service
Problem Possible Cause
Timer Does Not Work The timer cannot be used while the oven is self-cleaning.
Oven Temperature Too 
Hot Or Too Cold
Oven thermostat needs adjustment. See the Oven thermostat adjustment 
section. 
Oven Door Will Not Open 
After A Clean Cycle
The oven is too hot. Allow the oven to cool below locking temperature.
“Err Turn Surface 
Burners Off” Scrolls In 
The Display
Self-clean is in progress and the Cooktop Lockout feature is activated. No 
surface cooking is permitted during the self-clean operation. Wait until the 
self-cleaning operation has been completed.
“Close Door” Scrolls In 
The Display
The self-clean cycle has been selected but the door is not closed.
Close the oven door. The 
 symbol will appear in the display
 Is On When You Want 
To Cook
The oven door is locked because the temperature inside the oven has not 
dropped below the unlocking temperature. Turn the Oven Mode Selector 
and the Temperature knobs to OFF. Allow the oven to cool.
F- And A Number Flash 
In The Display
The oven has a function error code. Turn the Oven Mode Selector and the 
Temperature knobs to OFF. Allow the oven to cool for one hour. Put the 
oven back into operation.
Disconnect all power to the oven for 30 seconds and then reconnect 
power. If the function error code repeats, call for service.
Display Goes Blank The display is blank when the oven or timer is not in use.
A fuse in your home may be blown or the circuit breaker tripped. Replace 
the fuse or reset the circuit breaker.
Unable To Get The 
Display To Show “Sf”
The TIMER and the MINI-KNOB buttons must be pushed at the same time 
and held for 4 seconds. 
“Probe” Appears In The 
Display
This is reminding you to enter a probe temperature after plugging in the 
probe. Enter a probe temperature
 Shows In Display
The Sabbath mode has been selected.
Power Outage If the oven was in use during a power outage or surge, the oven must be 
reset. Turn the Temperature knob and the Oven Mode Selector to OFF. 
Reset the controls to begin again. 
Steam From The Vent When using the convection mode, it is normal to see steam coming out 
of the oven vent. As the number of racks or amount of food being cooked 
increases, the amount of visible steam will increase.
Burning Or Oily Odor 
Emitting From The Vent
This is normal in a new oven and will disappear in time.
Strong Odor This is temporary. An odor from the insulation around the inside of the 
oven is normal for the first few times the oven is used.
Fan Noise A cooling fan or a convection fan (depending on the function you are 
using) may turn on. This is normal. The cooling fan will turn on to cool 
internal parts. It may run after the oven is turned off. The convection fan 
may cycle on and off until the function is over or the door is opened.
Troubleshooting Tips
Professional All-Gas Range










