Installation Instructions

6 31-2001053 Rev. 0
Installation Information
BEFORE YOU BEGIN
Read these instructions carefully and completely.
• IMPORTANT — Save these instructions
for local inspector’s use.
• IMPORTANT — Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Proper installation is the responsibility of the installer
and product failure due to improper installation is
NOT covered under warranty.
• Note – This appliance must be properly grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired (direct
wired) into an approved junction box. A plug and
receptacle is NOT permitted on these products.
PARTS INCLUDED
(Appearance will vary)
Brush
Metal Peel
Top Grille
Assembly
Bottom
Grille
Wooden Peel
Upper &
Lower Grille
1/2” T20 Torx
(8)
3/4” Phillips
Screws (2)
MATERIALS NEEDED
TOOLS NEEDED
Strain Relief Clamp
for 1/2” conduit
Plaster Ring and Cover
(Option 1)
Wire Strippers
Junction Box
(1 1/2 Depth Max.)
Phillips #2
Screwdriver
Flathead
Screwdriver
T20 Torx Screwdriver
Drill and 3/32” drill bit
Wire Nuts
Option 1
Option 2