Installation Guide

12 31-2001053 Rev. 0
Installations
1 F
HEARTH OVEN OVER WALL OVEN – FLUSH-INSET INSTALLATION WITH A
2” PLATFORM BETWEEN
A
45” is the required minimum installation height. Oven
may be installed higher based on owner preference.
B
Hearth Oven Platform must be able to support
200 lbs. (91kg).
C
Solid enclosure required on the top, bottom, left
side, right side and back. The back surface may
be drywall. Advanced fabrication and assembly
techniques are strongly encouraged to ensure
precise cabinet squareness and parallelism.
D
Junction box location: Must be flush with back
surface so as not to extend into the 24-15/16”
cabinet depth. Junction box may also be located in
an adjacent cabinet.
E
The front surface of the interior cleats shall be a
finished appearance surface.
F
The Wall Oven REQUIRES an extruded aluminum
LOWER VENT TRIM. Wall oven models beginning
with “ZTSX” already include the aluminum vent
trim. For models beginning with “ZTS”, the vent trim
kit ZX30VT1 must be ordered which includes the
aluminum vent trim and mounting hardware.
Please call 1-800-626-2000 with any questions.
G
The opening center line dimension is taken at the
FRONT OPENING of each enclosure.
H
Wall Oven bottom surface cleat is to be ¼” thick
MDF fiber board or equivalent.
ELEC.
SEE NOTE D
ELEC.
SEE NOTE D
HEARTH OVEN PLATFORM
SEE NOTE B
4
1
2
"
10"
5
1
4
"
9
1
2
"
A
A
28
5
32
"
C
L
TO
C
L
SEE NOTE G
24
15
16
"
CABINET DEPTH
SECTION A-A
3
4
"
CLEAT
3
4
"
CLEAT
3
4
"
CLEAT
3
4
"
CLEAT
1
1
8
"
CLEAT
1
1
8
"
CLEAT
45" MIN.
30"
CUTOUT WIDTH
30"
CUTOUT WIDTH
23
11
16
"
7
8
"
HEARTH OVEN
CLEAT SETBACK
28
5
8
"
1
7
16
"
WALL OVEN
CLEAT SETBACK
1
4
"
MDF CLEAT
SEE NOTE H
2
1
2
"
CLEAT
DEPTH
2"
BETWEEN
CUTOUTS