Installation Instructions

12 31-11062-1
3
INSTALLING THE OVEN IN THE
CABINET (Cont.)
B
WITH TRIM KIT
1. Before lifting oven into cabinet cutout, remove six
screws from top vent and attach top grille to top of
oven using the same screws as shown.
2. Lift oven into cabinet cutout using the bottom as a
grip. Do not lift by the oven opening.
3. Carefully slide the oven back into the cutout until
the top grille just touches the front face of the
cabinet. NOTE: Do not push too for or damage to
the top grille may occur.
4. Pre-drill top grille mounting holes into cabinet using
3/32” drill bit and the hole in the trim as a guide.
5. Remove these two screws from the bottom.
3
INSTALLING THE OVEN IN THE
CABINET (Cont.)
6. Align bottom grille by inserting alignment posts into
pizza oven front and pre-drill mounting holes using
3/32” drill bit, ensuring there is no gap between the
grill and the oven.
NOTE: A 2” wide by 30” long masking tape strip can
be used to hold the bottom grille tightly to the bottom
of the oven while the mounting holes are drilled.
7. Starting at the top, attach grilles and side trim
using supplied 3/4” phillips screws and the 3/32”
holes drilled previously, as shown.
NOTE: Oven shown extended from cabinet for
clarity of assembly. Side trim should be installed
with oven and grille flush to cabinet frame.
Installation Instructions
No Gap
Top Grille
Bottom Grille
45°
Screws
45°
Top Grille
Side Trim
Pre-drilled Hole