Specifications

Safet Information
BEFORE YOU BEGIN:
Read these instructions completelg and carefullg.
IMPORTANT - Savetheseinstructions
for local inspector's use.
IMPORTANT -Observeallgoverning codes
and ordinances.
Note to Installer - Be sure to leave these
instructions with the Consumer.
Note to Consumer - Keepthese instructions with
your Owner's Hanual for future reference.
_WARNING - This appliance must
be properly grounded. Seepage 5.
_AVERTISSEMENT -
Cet appareil doit _tre correctement mis 5 la terre.
Consultez page 5.
If you received a damaged wine chiller, wine reserve
or beverage center, you should immediately contact
your dealer or builder.
Skill Level -Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GEAppliance Warranty.
_WARNINGS:
• Usethis appliance only for its intended purpose.
• Immediately repair or replace electrical service cords
that become frayed or damaged.
Unplug the unit before cleaning or making repairs.
Repairs should be made by a qualified service
technician.
_k AVERTISSEMENT :
• IIne faut utiliser cet appareil que pour I'usage pour
lequel il a _t_ construit.
IIfaut r_parer ou remplacer imm_diatement tout
cordon d'alimentation _lectrique effiloch_ ou
endommag_.
D_brancher le bar ou le r_frig@ateur a vin avant
le nettoyage ou toute intervention.
Les r_parations doivent _tre faites par un technicien
qualifi_.
For Monogram local service in gour area, call
1.800.444.1845
For Monogram service in Canada, call
1.800.561.3344
For Monogram Parts and Accessories, call
1.800.626.2002.
www.monogram.com
CONTENTS
Design Guide
The Instollotion Spoce..............................3
Side-by-Side Instollotions .....................4
Product Clearances .................................../4
Installation Instructions
Tools Required ..............................................5
Grounding the Product ...........................5
Staining Wood Drawer Fronts .............5
Installing the Custom Frame Panel ...5
Step 1, Remove Packaging ....................5
Step 2, Reverse Door Swing ...................6
Step 5, Level ..................................................7
Step/4, Connect Power .............................7
Step 5, Slide Product into Cutout .........7
Step 6, Install Nameplate ........................7
Step 7, Set Temperature Controls .......7
Custom Frame Panel Hodels ................7
Template for Nameplate.... Back Cover