Owners Manual

49-85247 35
The electrode of the electronic ignition system
is positioned at the rear of the burner base.
When cleaning the cooktop, be careful not
to snag the igniter with your cleaning cloth.
Damage to the igniter could occur.
Be careful not to push in a control knob while
cleaning. It could cause the igniter to spark.
Make sure that the white ceramic igniters
on the cooktop are dry and clean. Clean the
metal portion of the electrode with a soft cloth
or emery board.
Do not attempt to remove the electrode
from the cooktop.
Care and Cleaning
Professional Dual Fuel Range
Spark
igniter and
electrodes
Clean this metal part
with an emery board.
Do not clean this white
ceramic part with an
emery board.
Burner
grates
The enameled cast-iron burner grates should
be cleaned regularly.
You must put the grates on the self-clean
oven rack during the self-clean cycle. DO
NOT put the grate on the oven floor during a
self-clean cycle. DO NOT put the frame inside
the oven during a self-clean cycle. Only the
grate can withstand the heat of the self-clean
cycle. The frames may be cleaned by hand or
in the dishwasher.
Wash them in hot soapy water, rinse, and dry
thoroughly.
Although they are durable, the grates will
gradually lose their shine, regardless of the
best care you can give them. This is due to
their continual exposure to high temperatures.
Do not operate a burner for an extended
period of time without cookware on the grate.
The finish on the grate may chip without
cookware to absorb the heat.
For stability, the frames have rubber pads
on each corner. During cleaning and use, be
careful not to damage or snag rubber pads.
Grates
Frame
Pads