Quick Specification

PAGE 3 OF 4
For questions about your
appliance, please call 1-800-626-2000.
Product Specication Revised 3/22
All Dual-Fuel Professional Ranges are factory set for natural gas.
NOTE
A propane conversion kit is included with the range. High
Altitude kit for operation above 6,000 feet (for Natural
and LP gas models), is available at an additional cost. The
conversion must be performed by a qualied gas installer at
additional cost.
HA NG Service Kit: WB28X39726
HA LP Service Kit: WB28X39727
INSTALLATION INFORMATION
Before installing, consult installation instructions packed with
product or online at Monogram.com for current dimensional
data. A suitable overhead vent hood is required for models
with a grill and is recommended for all other models.
ADVANCE PLANNING
Refer to dimensional drawings for appropriate placement
and necessary clearances when planning the installation.
• Working areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.
• Clearance between range and side wall or combustible
material must be at least 12" on each side.
• Installation must conform with local codes. In the absence
of local codes, the range must comply with the National
Fuel Gas Code, ANSI Z223.1-1990.
HELPFUL TIPSDIMENSIONS AND INSTALLATION
INFORMATION (IN INCHES)
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall
on each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.
Non-Combustible
Material**
16"
Max.
18"
Min.
48" Min.
12" Minimum
Each Side
12" Minimum
to Adjacent Wall
**As defined in the National Fuel Gas Code
(ANSI Z223.1/CSA B149.1, Current Edition).
Clearances from non-combustible materials
are not part of the ANSI Z21.1/CSA 1.1 scope
and are not certified by CSA. Clearances less
than 12” must be approved by local codes
and/or the authority having jurisdiction.
WARNING
A suitable overhead vent hood is required. A custom hood
installation with exposed horizontal combustible surfaces
must have an Auto-On feature. Refer to hood installation
instructions for specic hood clearances.
The surface of the entire back wall above the range and
below the hood must be covered with a non-combustible
material such as metal, ceramic tile, brick, marble or other stone.
** As dened in the National Fuel Gas Code (ANSI Z223.1/CSA
B149.1, Current Edition). Clearances from non-combustible
materials are not part of the ANSI Z21.1/CSA 1.1 scope and
are not certied by CSA. Clearances less than 12” must
be approved by local codes and/or the authority having
jurisdiction.