Specifications Sheet
PAGE 3 OF 4
For questions about your
appliance, please call 1-800-626-2000.
Product Specication Revised 11/20
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall
on each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.
Non-Combustible
Material
13"
max.
18"
min.
36" min.
48" minimum
to combustibles
12" minimum
each side
12" minimum
to adjacent wall
HELPFUL TIPS
WARNING
Installations without a hood require 48" minimum to
combustibles. A custom hood installation with exposed
horizontal combustible surfaces must have an Auto-On
feature. Refer to hood installation instructions for specific
hood clearances.
e surface of the entire back wall above the range and below
the hood must be covered with a non-combustible material
such as metal, ceramic tile, brick, marble or other stone.
Professional ranges offer a number of choices in size
and cooktop configurations.
All Dual-Fuel Professional Ranges are factory set
for natural gas.
NOTE
A propane conversion kit is included with the range. High
Altitude kit, WB28K10553 for operation above 6,000 feet (for
Natural and LP gas models), is also available. e kits must be
installed by a qualified service technician at additional cost.
INSTALLATION INFORMATION
Before installing, consult installation instructions packed with
product or online at Monogram.com for current dimensional
data. A suitable overhead vent hood is required for models
with a grill and is recommended for all other models.
ADVANCE PLANNING
Refer to dimensional drawings for appropriate placement
and necessary clearances when planning the installation.
• Working areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.
• Clearance between range and side wall or combustible
material must be at least 12" on each side.
• Installation must conform with local codes. In the absence
of local codes, the range must comply with
the National Fuel Gas Code, ANSI Z223.1-1990.
DIMENSIONS AND INSTALLATION
INFORMATION (IN INCHES)