Owners Manual

49-85247 37
The IR Grill should be cleaned immediately after each use.
1. Clean the Grill Grate:
Turn the burner to OFF. Use a barbecue
mitt to remove the hot grill grate. Place the
grill grate in a basin or sink and scrub with a
brass bristle brush. Rinse frequently.
The grill grate may also be cleaned in the
oven during the self-cleaning cycle, or, it
can be cleaned in the dishwasher.
2. Clean the Grill Grate Frame:
The grill grate frame can be cleaned by
hand or in the dishwasher. Do not clean the
grill grate frame in a self-cleaning oven. The
grill grate frame has rubber pads on each
bottom corner. Be careful not to damage the
pads during the cleaning process.
3. Clean the Radiant baffle:
Lift the baffle out of the pan. Clean the baffle
with hot soapy water or in the dishwasher.
4. Clean the Pan Surround, Wire Mesh:
The pan surround and wire mesh cannot be
removed. Clean them in place. Use a soft
damp cloth to clean the pan surround. Gently
brush food particles into the grease trough or
use a vacuum cleaner for excess debris.
IMPORTANT: Keep the grill burner and
ceramic igniter dry. Do not spray water or
cleaner directly onto the wire mesh or igniter.
Avoid contact with the igniter, it is fragile and
can chip or break.
Reassemble the Grill:
Reverse the steps above to reassemble the
grill. The radiant baffle support tabs should
engage the pins on the side of the pan
surround. Replace the grate frame. Be sure
to engage the bottom locater pin with the pin
hole at the left rear side of the pan. Replace
the grill grate with the handle end towards the
front of the range.
Care and Cleaning
Professional Dual Fuel Range
Grill grate,
frame and
baffle
(on some models)
1. Grill Grate
2. Grate Frame
Support Tabs
Glo-Bar Igniter
3. Radiant Baffle
4. Pan Surround
Wire Mesh
Burner
Locater
Pin Hole