Quick Start Guide

31-51542-6 7
STEP 2 LEVEL
• Use an adjustable wrench to turn and raise or lower the
leveling legs.
0HDVXUHÀRRUWRFRXQWHUWRSKHLJKWLQVLGHWKHRSHQLQJ
Adjust leveling legs until the product is approximately
ƎOHVVWKDQFRXQWHUWRSKHLJKW
INSTALLATION TIP:
0HDVXUHÀRRUWRXQGHUVLGHRIFRXQWHUWRSLQVLGHWKH
opening.
,IWKHURRPÀRRULVKLJKHUWKDQWKHÀRRULQVLGHWKH
opening, adjust the rear leveling legs to approximately
ƎOHVVWKDQWKHRSHQLQJKHLJKW6FUHZIURQWOHYHOLQJ
legs all the way in to shorten the height at the front.
This will allow you to slightly tip the unit into the
opening. Once the unit is in the correct position, the
front legs can be adjusted to level the product.
Installation Instructions
STEP 5 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner’s Manual for more information. Allow 12–24
hours for temperature to stabilize.
NOTE: The Outdoor/Indoor Refrigerator operates very
quietly. You may not notice the unit running, and when
¿UVWLQVWDOOHGWKHIDQVDQGPRWRUPD\QRWFRPHRQ
immediately—this is normal. If the display is lit and the
light is working, the unit is operating.
STEP 3 CONNECT POWER
• If the refrigerator is used outdoors, plug the power cord
into a GFCI receptacle.
• Check to make sure power is on by opening the door to
see if interior light turns on.
• The interior fan runs at all times except when the
door is open. See the the Owner’s Manual for further
explanation.
STEP 4 SLIDE PRODUCT INTO THE
CUTOUT
NOTICE: Do not push against the door with your
knees. Do not push or lift the unit by the door handle.
Damage may occur!
• Open the door and gently push the unit back into the
opening with your hands against the sides. Be careful
not to entangle power cord.
,QDVWDQGDUGƎRSHQLQJWKHGRRUZLOOSURWUXGHƎ
forward of the surrounding cabinets.
• Check again to be sure the unit is level.
• If the unit is installed under a countertop, adjust the
OHYHOLQJOHJVXQWLOWKHXQLWLVUHVWLQJ¿UPO\DJDLQVWWKH
bottom of the countertop.
• If alignment with adjacent cabinetry is an issue, use
a shim to secure the unit against the underside of the
countertop.
• Test the door swing. Carefully open and close the door.
The door should not rub or catch on adjacent cabinetry.
Notify the installer if the door makes contact with
cabinetry.
STEP 1 REMOVE PACKAGING
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective plas-
tic coverings.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
AVERTISSEMENT
Les petits objets peuvent
étrangler les enfants. Il faut jeter toutes les piéces
qui ne sont pas utilisées.
Turn Right to Lower
Turn Left to Raise
STAINING WOOD DRAWER
FRONTS
7KHGUDZHUIURQWVDUHXQ¿QLVKHGFKHUU\ZRRG'XULQJ
use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to match
adjacent cabinetry.
• Apply the stain and sealer according to the
manufacturer’s instructions. To avoid unpleasant odor,
keep the door open to ventilate and allow the stain/
sealer to dry completely before using the product.