Installation Guide

6
31-1000645
PREPARATION FOR BUILT-IN
UNDER-COUNTER INSTALLATIONS
ONLY
The top canopy may be removed when installing under
a countertop.
• Remove the three screws from the back of the top
canopy (A).
• Using heavy-duty work gloves, lift up on the top
canopy back (B) and slide it forward until it unlatches
from the unit (C).
/LIWWKHWRSFDQRS\XSDQGRႇRIWKHXQLW
NOTE: Keep the top canopy and screws for future free-
standing installations.
NOTE: When installing the unit in a free-standing
FRQ¿JXUDWLRQWKHWRSFDQRS\PXVWEHOHIWLQSODFH
• If replacing the top canopy make sure the three latches
in the front slide into the front lip of the canopy before
pushing the canopy to the rear of the unit.
CAUTION
Under side edges of the stainless
steel canopy top may be sharp. Wear heavy-duty work
gloves when moving the top.
ATTENTION
Les bords du dessus en acier
inoxydable du réfrigérateur peuvent être acérés. Portez
des gants lorsque vous le retirez.
Design Guide
(A)
(B)
(C)
PRODUCT CLEARANCES AND
LOCATION REQUIREMENTS
The Outdoor/Indoor Refrigerator is factory set for
a 110° door swing.
When installed in a corner:
$OORZƎPLQFOHDUDQFHRQWKHhinge side for
the 90° door swing and to allow racks to slide out.
$OORZƎPLQLPXPFOHDUDQFHRQWKHhinge side for
a full 110° door swing.
• Test the door swing. Carefully open and close the door.
Adjust if the door makes contact with cabinetry.
15" Minimum
to Wall
110˚
110˚
Door
Swing
5-1/4" Minimum
to Wall
Û
Û
Door
Swing
R
F
B