Specification

NOTES
INSTALLATION
Installation Space
The Monogram
®
Beverage
Center may be installed
beneath a countertop or can
be used free-standing.
• If installing between
frameless cabinets, a
1/2"-wide filler strip or side
panel may be required.
The filler strip will act as
a spacer between the
door case and adjacent
cabinet and will prevent
interference with cabinet
door swing. The width of
the opening must include
filler panel.
Note: When installed,
the door should project
forward 1" of adjacent
24"-deep cabinets.
Location Requirements
All Monogram Refrigeration
Modules may be closed in
on the top and sides as long
as the front is unobstructed
for air circulation and door
swing.
• Do not install these
products where the
temperatures will go below
55°F (13°C) or above 90°F
(32°C).
• Do not install where they
will be subject to direct
sunlight, heat or moisture.
• These products are not
designed to be stacked one
over the other.
Side-by-Side Installation
For a complete refreshment
center, install a Monogram
Wine Reserve and Beverage
Center together.
• Products must operate
from separate properly
grounded receptacles.
Door Swing Clearances
All Monogram Refrigeration
Modules are factory set for a
110° door swing.
When installed in a corner:
• Allow the minimum door
swing clearances shown.
• The minimum clearance
shown at 90° will allow full
extension of drawers and
shelves.
34 1/2"
(87.7)
Min
underside of
counter to floor
35" (89) Max
24"
(60.1)
min cutout depth
FLUSH CUTOUT INSTALLATION
SIDE VIEW
INSTALLATION CUTOUT
FRONT VIEW
10 1/2" (26.7)
1 1/2" (3.8)
23 3/4" (60.3) Min
cutout width
9" (22.9)
Max
ELECTRIC
ZDBC240NBS
GE Monogram
®
Beverage Center
Product Specification Created 7/14
ZDBR240HBS