Material Safety Data Sheets

Product Specification Revised 7/16
ZDBI240HIIMONOGRAM BEVERAGE CENTER
INSTALLATION
1/8"
(0.3)
Cut the notch
1/8" (0.3) deep, 1/4" (0.6)
wide and 1/4" (0.6)
high
GLASS
23 1/8"
(58.7)
2 1/4"
(5.7)
2 1/4" (5.7)
wide
all sides
18 5/8"
25 1/4"
2 1/2"
(5.1)
2 1/4"
(5.7)
1/4"
(0.6)
1/4"
(0.6)
30"
(76.2)
Route the
back side
of the
opening
7/16" (1.1) deep,
1 1/8" (2.9) wide
Route the
back side
of the
opening
7/16" (1.1) deep,
1 1/8" (2.9) wide
GLASS
23 1/8"
(58.7)
2 1/4"
(5.7)
2 1/4" (5.7)
wide
all sides
18 5/8"
(47.3)
2 1/4"
(5.7)
2 1/4"
(5.7)
29 3/4"
(75.6)
25 1/4"
(64.1)
CUSTOM PANEL
OPTION 1
CUSTOM PANEL
OPTION 2
ZDBI240WII, ZDWI240WII
10 1/2" (26.7)
1 1/2" (3.8)
23 3/4" (60.3) Min
cutout width
9" (22.9)
Max
ELECTRIC
34 1/2"
(87.7)
Min
underside of
counter to floor
35" (89) Max
24"
(60.1)
min cutout depth
FLUSH CUTOUT INSTALLATION
SIDE VIEW
INSTALLATION CUTOUT
FRONT VIEW
Installation Space
The Monogram
®
Beverage
Center may be installed
beneath a countertop or can
be used free-standing.
• If installing between
frameless cabinets, a 1/2"-
wide filler strip or side
panel may be required.
The filler strip will act as
a spacer between the
door case and adjacent
cabinet and will prevent
interference with cabinet
door swing. The width of
the opening must include
filler panels.
Note: When installed, the
door should project
forward 1" of adjacent
24"-deep cabinets.
Location Requirements
All Monogram Refrigeration
Modules may be closed in
on the top and sides as long
as the front is unobstructed
for air circulation and door
swing.
• Do not install these
products where the
temperatures will go below
55°F (13°C) or above
90°F (32°C).
• Do not install where they
will be subject to direct
sunlight, heat or moisture.
• These products are not
designed to be stacked
one over the other.
Side-by-Side Installation
For a complete refreshment
center, install a Monogram
Wine Reserve and Beverage
Center together.
• Products must operate
from separate properly
grounded receptacles.
Door Swing Clearances
All Monogram Refrigeration
Modules are factory set for a
110° door swing.
When installed in a corner:
• Allow the minimum door
swing clearances shown.
• The minimum clearance
shown at 90° will allow full
extension of drawers and
shelves.
NOTES