Design Guide with Installation Instructions Wine Chiller, Wine Reserve and Beverage Center monogram.
Safety Information BEFORE YOU BEGIN If you received a damaged refrigerator, you should immediately contact your dealer or builder. Skill Level – Installation of this refrigerator requires basic mechanical, carpentry and plumbing skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. See the Owner’s Manual for warranty information. Read these instructions completely and carefully.
Consignes de Sécurité Ce symbole représente une alerte de sécurité. Ce symbole vous avise de dangers possibles pouvant causer la mort, des blessures ou autres. Tous les messages de sécurité seront précédés du symbole d’alerte de sécurité ainsi que des mots « DANGER », « AVERTISSEMENT » ou « MISE EN GARDE ». Ces messages sont les suivants : DANGER Signale une situation qui présente un danger imminent et qui, si elle n’est pas évitée, entraînera des bles sures graves, voire la mort.
Design Guide THE INSTALLATION SPACE CONTENTS Important Information .................................................................... 2, 3 Design Guide Tools Required ............................................................................................. 4 Parts Supplied .............................................................................................. 4 Staining Wood Drawer Fronts ........................................................... 4 Installing Custom Frame Panel .............
Design Guide THE INSTALLATION SPACE (cont.) Flush Installation Standard Installation Dim. A Filler panel or cleat to be set back even with front of case. CABINET Front edge of product case CABINET CABINET Dim. A 110° Front face 120° Product ZDWI240, ZDBI240 Dim. A ZDWI240, ZDBI240 1" ZDWC240, ZDWR240 1/2" ZDBC240, ZDBR240 1/2" PRODUCT CLEARANCES Dim. A 2" ZDWC240, ZDWR240 1-3/4" ZDBC240, ZDBR240 1-3/4" • These products are not designed to be stacked one over the other.
Installation Instructions STEP 1 REMOVE PACKAGING STEP 2 REVERSE DOOR SWING (Cont.) • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. • Remove stainless steel toekick taped to the back of the unit. 3HHO EDFNLQJ RȺ WKH WDSH LQVLGH WKH GHFRUDWLYH KLQJH cover. • Press and snap the hinge cover Install Covers into place. • Snap the screw hole cover into place on the opposite side. WARNING Small objects are a choke hazard for children.
Installation Instructions CUSTOM FRAME PANEL MODELS STEP 3 LEVEL Model ZDWI240WII and ZDBI240WII These models require a custom panel frame surrounding the glass. There are two options: the panel may be 29-3/4s or 30s high. A 30s panel requires a notch cut into the bottom of the panel to avoid interference with the hinges. • Rout the back side of the panel to the dimensions shown. • A custom handle of your choice or ZTBSS1 Tubular Handle must be installed before the panel is mounted onto the door.
Note: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram® local service in your area, call 1.800.444.1845. Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specL¿FDWLRQV DUH VXEMHFW WR FKDQJH ZLWKRXW QRWLFH Pub. No. 31-46122-4 Part No. 197D7840P001 01-15 GE Printed in Slovenia GE Appliances Appliance Park Louisville, KY 40225 GEAppliances.
