Operating instructions

Before You Call For Service
Dishwasher
Questions?
Use this
problem
solver
PROBLEM POSSIBLE CAUSE WHAT TO DO
Sanitized light does not
illuminete at the end of
the cycle {Anti-Bacteria
cycle only)
Interior lights not
working
The door was opened and
the cycle was interrupted
during or after the main
wash portion
Low inlet water
temperature
Door was open for more
than !B minutes
• Do not interrupt the cycle any time during
or after main wash,
• Raise the water heater temperature to
at least 120°F (4g°c).
• Latch the door and reopen.
Bulbs are burned out • Call for service to replace bulbs.
End-of-cycle indicator Dishwasher has not • Open the door and check the status
light does not illuminate completed cgcle indicator lights on control panel to
determine if cgcle is complete.
Beeps every 30 seconds • Close the door to complete the cgcle.
START/RESETlight blinks
Door was opened
during the cycle
START/RESETpad was
pressed during the cgcle
Power failure during
the cycle
Dishwasher will pump out for approximately
70 seconds and blinking light will turn off,
Dishwasher will pump out for approximately
70 seconds and blinking light will turn off,
Dishwasher will automatically restart using
NORMALWASHand HEATEDDRY.
19