Owner`s manual
20
INSTALL SWITCHBOX AND BRACKET
Installation Instructions
• Reinstall the bracket(s) using screws removed
earlier. Make sure the wires go OVER the bracket
and out of the way before installing.
NOTE: Make sure the door hinge does not pinch
the wires hanging down from the switchbox when
closing the door.
• Cover any exposed wiring on the refrigerator
connectors with UL approved electrical tape.
WARNING: No wires are to be exposed.
• Write the installation date on the ZSAB1 switchbox.
• Place the Sabbath Mode Product Kit Technical Data
Sheet with the refrigerator’s Technical Data Sheet
for future use.
• Reinstall the grille on All-Refrigerator models
in the same manner as it was removed.
• Close the grille panel.
• Replace the house fuses or reset the circuit breaker.
• Lower the grille panel.
INSTALLING SABBATH MODE SWITCHBOX
All-Refrigerators and All-Freezers “X” Models Only
OPERATION CHECKLIST
With the Sabbath Switch set to OFF:
With the Sabbath Switch set to ON:
Make sure the green LED light is on.
Open the fresh food door and freezer drawer
to make sure the lights do not come on and
the temperature display does not come on.
Listen to make sure the compressor is running.
Confirm that the kit wires are properly routed and
that no AC wires are exposed at the unit connector
side. Use UL approved electrical tape to cover
wires completely.
Confirm that the Sabbath Mode Product Kit
Technical Data Sheet has been placed with the
refrigerator’s Technical Data Sheet for future use.
Confirm that the installation date has been written
on the ZSAB1 switchbox.
Leave the Installation Instructions
with the consumer for future use.
Make sure the green LED light is off.
Listen to make sure the compressor is running.
Open the door and confirm that the interior lights
and the temperature display operate normally.
If the interior lights do not come on, the Master
Light Switch may have been accidentally set
to the OFF position. Make sure the Master Light
Switch is in the ON position.
All-Freezer model shown