Owner`s manual

MAKING ELECTRICAL CONNECTIONS

• Locate the refrigerator’s AC Input and Output

connectors to the right of the water filter.

• Disconnect the refrigerator’s AC Input and Output

connectors from each other.

NOTE: If possible, try to avoid exposing the wires

attached to the refrigerator’s AC connectors.

MOUNT SWITCHBOX

• FOR PERSONAL SAFETY: Unplug the refrigerator,

remove house fuse or open circuit breaker before

beginning installation.

• Open the grille panel.

• Place a sheet or towel over the top of the fresh food

door to prevent accidentally scratching the door

panel.

• Place the switchbox against the left side of the grille

panel opening, placing the switchbox as far toward

the front of the refrigerator as possible.

– Make sure to leave clearance for the door hinge

(if necessary).

– Make sure the green LED light on the side

of the switchbox is pointing DOWN.

• Mount the switchbox using the two self-tapping

screws included with the kit.

IMPORTANT: DO NOT DRILL HOLES IN THE SIDE

OF THE REFRIGERATOR. USE THE SELF-TAPPING

SCREWS SUPPLIED WITH THE KIT.

Installation Instructions

INSTALLING SABBATH MODE SWITCHBOX

Bottom-Freezer Refrigerators “R” Models Only

If your Bottom-Freezer refrigerator is an “X” model, go to page 14.

Sheet or Towel

Refrigerator

AC Connectors

AC Connector

Wire

Screws

DC Connector

Wire

Green

LED Light