Owner`s manual

MAKING ELECTRICAL CONNECTIONS (cont.)
• Replace the water filter bracket and water filter.
• Place the switchbox against the evaporator housing
to the left of the main control board cover (on 36"
and 42" models) or to the right of the main control
board cover (on 48" models). Make sure the green
LED light on the side of the switchbox is pointing
DOWN.
• Mount the switchbox to the evaporator housing
using the two self-tapping screws included with
the kit.
IMPORTANT: DO NOT DRILL HOLES IN THE
EVAPORATOR HOUSING. USE THE SELF-TAPPING
SCREWS SUPPLIED WITH THE KIT.
If desired, the top of the switchbox can be mounted
using a screw from one of the plastic wire straps
at the top of the evaporator housing.
• Write the installation date on the ZSAB1 switchbox.
• Place the Sabbath Mode Product Kit Technical Data
Sheet with the refrigerator’s Technical Data Sheet
for future use.
• Close grille panel.
• Replace house fuses or reset circuit breaker.
10
Installation Instructions
INSTALLING SABBATH MODE SWITCHBOX
Side-by-Side Refrigerators “X” Models Only (cont.)
Screws
DC Connector Wire
Green LED Light
OPERATION CHECKLIST
With the Sabbath Switch set to OFF:
With the Sabbath Switch set to ON:
 Make sure the green LED light is on.
 Open the fresh food and freezer doors to make sure
the lights do not come on and the temperature and
Climate Control Drawer displays do not come on.
 Press the temperature and Climate Control Drawer
controls to make sure they do not light up or beep.
 Try to dispense water or ice from the dispenser.
Ice or water should not dispense.
 Press the dispenser controls to make sure they
do not light up.
 Listen to make sure the compressor is running.
 Confirm that the kit wires are properly routed
and that no AC wires are exposed at the unit
connector side. Use UL approved electrical tape
to cover wires completely.
 Confirm that the Sabbath Mode Product Kit Technical
Data Sheet has been placed with the refrigerator’s
Technical Data Sheet for future use.
 Confirm that the installation date has been written
on the ZSAB1 switchbox.
 Leave the Installation Instructions with the consumer
for future use.
 Make sure the green LED light is off.
 Make sure the dispenser is operating normally.
 Listen to make sure the compressor is running.
 Open the fresh food and freezer doors and confirm
that the interior lights, the temperature display
and the Climate Control Drawer all operate normally.
If the interior lights do not come on, the Master Light
Switch may have been accidentally set to the OFF
position. Make sure the Master Light Switch is in
the ON position.