Installation Guide

31-1000416 Rev. 0
32
STEP 4 INSTALL ANTI-TIP BRACKET (Cont.)
Drill 1/2” (1.27 cm) holes into the wall board at the
locations marked for the toggles to be mounted (not the
stud markings).
Drill 3/16” (0.47 cm) holes into wooden studs where
marked. If steel stud construction, drill 1/2” (1.27 cm)
holes into the studs where marked. You will use 2
toggles with the metal studs.
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service Kit
#WR49X10193. Wall toggles are installed in the drywall
and metal studs for stability. Install the wall toggles as
follows:
Drill 1/2” (1.27 cm) holes at the wall markings made in
the holes at the ends of the wall bracket.
Hold the metal channel flat
against the plastic straps
and slide the channel
through the hole.
Gently pull back at the ends
of the plastic straps to make the
channel rest flush behind the
wall.
Hold the ends of the straps in
one hand and slide the plastic
cap along the straps until the
flange of the cap is flush with the
wall.
Place your thumb between the
plastic straps and bend up and
down to snap the straps off at the
wall.
Install Screws and Bolts:
Have someone hold the
wall bracket centered in
place with each of the holes
aligned with the correct
opening in the bracket and
level with the horizontal
line.
Insert the lag screws
through the bracket and
into the stud. Tighten
with a wrench.
Insert the bolts into the
toggle by hand until
snug. Tighten with a
wrench.
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
Open the access door.
Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
Pull the bottom of the grille forward, down and out to
remove.
Freezer Unit
Open the access door.
Remove the 4 screws from the grille on the right and 3
screws from the grille on the left.
Pull the bottom of the grille forward, down and out to
remove.
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
Anti-Tip Wall Bracket
Bolt
Wall To
ggle
Drywall or
Steel Stud
Installation Instructions - Stainless Steel Installation
Wood Stud
Lag Screw
Anti-Tip Wall Bracket
Cap
Screws Screws
Plastic Straps
Metal Channel
Screws Screws