Instruction Manual

31-10700-6 7
Installation Preparation
NOTE: Additional clearance between cutouts may be
required. Check to be sure that oven supports above
the Warming Drawer location does not obstruct the
required interior 23-1/2” depth and 9-1/4” height.
INSTALLATION OPTIONS
Models
Dimensions
A B
ZW9000 28-1/2” 30”
ZJ7000 25-1/2” 26-3/4”
When installed under a wall oven:
Warming drawers are approved for installation below
only certain specified wall oven models. See the label
attached to the top of the warming drawer for approved
models.
■ When installed, the front face of the drawer will be
nearly flush with adjacent cabinetry doors.
■ Drawer overlaps will conceal cut edges on all sides of
the opening.
The rough opening for the drawer must be:
– Depth: 23-1/2” min. from inside back to front of
cabinet frame.
– Width: 25-1/2” for 27” wide models, 28-1/2” for 30”
wide models.
– Height: 9-1/4”.
– Allow 2” min. between oven and drawer cutouts for
clearance of overlaps.
NOTE: If you are installing in frameless cabinets, it may
be necessary to install 1/2” wide cleats to accept drawer
mounting screws. See drawer for mounting screw
locations.
Installation Below
a Single Oven
Installation Below
a Double Oven
2x2 or 2x4 Anti-Tip
Block Against Rear
Wall, 9” From Floor
to Bottom of Block
1” Min. Above Toekick
Allow 5/8”
Overlap on
All Sides
23-1/2”
Min.
Inside
Oven
Cutout
2” Min.
9”
A
B
9-1/4”
23-1/4”
10-1/2”
2x2 or 2x4 Anti-Tip
Block Against Rear
Wall, 9” From Floor
to Bottom of Block
1” Min. Above Toekick or Adjust
to Oven Installation Height
23-1/2”
Min.
Inside
Oven
Cutout
2” Min.
9”
A
B
9-1/4”
23-1/4”
10-1/2”
Allow 5/8”
Overlap on
All Sides