Instruction Manual

12 31-10700-6
BEFORE YOU BEGIN
Read these instructions completely and carefully.
■ IMPORTANT – Save these instructions
for local inspector’s use. Observe all governing
codes and ordinances.
■ Note to Installer – Be sure to leave these
instructions with the Consumer.
■ Note to Consumer – Keep these instructions for
future reference.
Installation
Instructions
PROFESSIONAL STYLE PANEL
ACCESSORY KIT
ZXD9030P
PARTS SUPPLIED
Stainless Steel Professional Style Drawer
Accessory
This kit contains a stainless steel professional style
panel with a handle and a lamp jewel imbedded in the
bottom right side. Install the warming drawer according
to the installation instructions packed with the product.
NOTE: The ZXD9030P professional drawer panel
with handle is a one-piece assembly that replaces
the original drawer front and tubular handle. The
original tubular handle (or a custom handle) cannot
be installed onto this professional drawer panel. This
ZXD9030P accessory is designed to fit 30” warming
drawers manufactured after January 2015.
TOOL AND MATERIALS REQUIRED
■ Phillips screwdriver
STEP 1
PREPARE DRAWER FOR
PANEL INSTALLATION
IMPORTANT: The drawer must be installed into the
cabinet before opening the drawer.
■ Openthedrawerapproximatelyhalfway.
■ Turnthewarmingdrawerto“OFF.”
STEP 2
REMOVE ORIGINAL
DRAWER FRONT
■ Remove the three screws from the bottom of the
drawer edge.
■ Remove the four screws on the inside of the
drawer at the top. Retain all screws.
– Support the drawer front as you remove screws
to prevent the front panel from falling
.
STEP 3
REMO VE THE PACKAGING
■ Open the carton and remove the panel.
Remove all protective covering on both sides.
CAUTION
Keep all plastic material away from
babies and small children. Plastic could pose a choking
or suffocation hazard.
STEP 4
INSTALL PANEL ONTO
DRAWER
■ Install the panel assembly to the exposed drawer
front using the original 7 screws.