Installation Instruction

14
31-46542-4
STEP 1 REMOVE PACKAGING
WARNING
Tip Over Hazard.
This appliance is top heavy. Use extreme caution
with moving to prevent tipping over which could
result in death or serious injury.
Ŷ Cut bands and tape on the top and bottom
of packaging with a utility knife.
Ŷ Unfold the cardboard seams and remove the top
of the packaging.
Ŷ Slide the remainder of the box off of the appliance. You
can use a box cutter to cut the remaining cardboard
being VERY CAREFUL not to scratch
the appliance.
Ŷ Remove the Styrofoam supports from around the unit.
Ŷ DO NOT remove door band or lower EPS banded part
until unit is ready to go into enclosure.
Ŷ Cut EPS skid at the sides near the front from the back
of the unit.
Ŷ Push unit forward & remove rear portion of the EPS
skid.
Ŷ Carefully lower rear onto the floor.
Ŷ Lean unit back slightly & remove front portion of the
EPS skid.
Ŷ Discard all unused packaging materials appropriately.
Ŷ The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
Ŷ Leave any protective film on the refrigerator until
installation is complete.
Installation Instructions